B
2
Operation
Turning Power On and Off
Press POWER on the front panel or remote control to turn the DCX set-top on or off
(standby). When using the remote control, be sure it is in cable mode by pressing
CABLE
before pressing
POWER. When using the front panel please note that the front panel
buttons are touch-sensitive, so simply touch the
POWER button to turn on the set-top.
Note: On initial power-up of the DCX set-top please wait for at least 2
seconds before touching the front panel controls.
Changing Channels
You can change channels in three ways:
• Press CHANNEL + or – on the front panel of the DCX set-top or the remote control to
step through the channel selection.
• Enter the number of the channel you wish to view using the number keys on the
remote control.
• Select the channel in the Interactive Program Guide.
Adjusting the Volume
Press VOLUME + or – on the remote control to adjust the volume. When you adjust the
volume, the volume scale is displayed on the screen. Press
MUTE on the remote control
to toggle the sound on and off.
For best audio quality when using the analog L/R (variable ) volume controlled audio
outputs, use the remote control to set the DCX set-top to approximately three quarters
of the maximum volume level and then adjust the audio levels on external devices such
as your TV or A/V receiver.
When using the analog L/R (fixed) audio outputs or any of the digital audio outputs
(HDMI, IEEE-1394, optical or coaxial digital audio) adjust the audio levels on your external
device such as your TV or A/V receiver. You may also be able to program your remote to
control the volume of your TV or A/V receiver directly (refer to the remote control
instruction manual).
2 • Operation 5
To Next Page
Loading...
Need help?
General
