Motorola DS6878 - Connecting the CR0078-P Series Cradle

1 - 10 DS6878 Product Reference Guide
Connecting the CR0078-P Series Cradle
Connect the interface cable and power supply (if necessary) in the following order to ensure proper operation of the
digital scanner and cradle:
1. Insert the interface cable into the cradle’s host port.
2. Connect the other end of the interface cable to the host.
3. Connect the power supply to the cradle’s power port.
4. Connect the appropriate cable to the power supply and AC power source.
5. Thread the interface cable over the cable support hook (see Figure 1-6 on page 1-6) and run the host and
power cables into their respective cable grooves.
6. If necessary (for non-autodetected interfaces), scan the appropriate host bar code (refer to the
CR0078-S/CR0008-S Cradle Quick Reference Guide for more information).
Figure 1-8 Connecting the Cables to the CR0078-P Cradle
Power Port
Host Port
Power Port
Host Port
Connect to appropriate host
Power
Alternate Host Groove
Alternate Power Groove