Standard Default Parameters A - 5
Emulate Keypad Disable
7-12
Emulate Keypad with Leading Zero Disable
7-12
Quick Keypad Emulation Disable
7-13
USB FN1 Substitution Disable
7-14
USB Static CDC Enable
7-14
Function Key Mapping Disable
7-15
Simulated Caps Lock Disable
7-15
Convert Case No Case Conversion
7-16
Ignore Beep Disable
7-17
Ignore Bar Code Configuration Disable
7-17
USB Polling Interval 8 msec
7-18
RS-232 Host Parameters
RS-232 Host Types Standard
8-6
Baud Rate 9600
8-8
Parity Type None
8-10
Data Bits (ASCII Format) 8-Bit
8-11
Check Receive Errors Enable
8-11
Hardware Handshaking None
8-12
Software Handshaking None
8-14
Host Serial Response Time-out 2 sec
8-16
RTS Line State Low RTS
8-17
Beep on <BEL> Disable
8-17
Intercharacter Delay 0 msec
8-18
Nixdorf Beep/LED Options Normal Operation
8-19
Ignore Unknown Characters Send Bar Code
8-19
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type IBM PC/AT& IBM PC
Compatibles
9-4
Table A-1
Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
