Motorola HT-1000 - Page 187

181
Scan Signalling
Field Function Location
Scan List Channels Allows channels to be entered into Scan List CHANGE:RADIO:SCAN LIST
SCAN LIST
Scan Type Selects whether Scan is priority or not CHANGE:RADIO:SCAN:CONFIG
PL Scan Selects how radio scans for PL CHANGE:RADIO:SCAN:CONFIG
Priority Chan Unmute Forces Selective Call Logic to true on Priority
Channel
CHANGE:RADIO:SCAN:CONFIG
Priority Chan Defn Selects how the Priority Channel is determined CHANGE:RADIO:SCAN:CONFIG
Fixed Priority Chan Selects a specific Priority Channel for Fixed
Priority
CHANGE:RADIO:SCAN:CONFIG
Designated Tx
Channel
Selects a specific channel for all transmissions in
Scan
CHANGE:RADIO:SCAN:CONFIG
Talkback Scan Enables Scan Talkback CHANGE:RADIO:SCAN:CONFIG
Scan Channel
Lockout
Drops channels from Scan List if they have wrong
PL
CHANGE:RADIO:SCAN:CONFIG
PL Defeat Allows Permanent Monitor while in Scan CHANGE:RADIO:SCAN:CONFIG
Nuisance Delete Allows deleting of channels with undesirable
activity
CHANGE:RADIO:SCAN:CONFIG
Sel Chan Unmute Forces Selective Call Logic to true on all Scan
channels
CHANGE:RADIO:SCAN:CONFIG
Quik-Call II Scan Enables Quik-Call II Decoder in Scan on Quik-call
II-enabled channels
CHANGE:RADIO:SCAN:CONFIG
MDC Decode Scan Enables MDC Decoder in Scan on MDC-enabled
channels
CHANGE:RADIO:SCAN:CONFIG
MDC Sel Cal Scan Enables scanning for MDC Sel Cal on MDC-
enabled channel
CHANGE:RADIO:SCAN:CONFIG
Tx/ Rx Hangtime (Sec) Sets time radio hangs on channel after activity
Stops
CHANGE:RADIO:SCAN:CONFIG
Side Button
Assignment
Assign Scan/Scan Programming functions to side
buttons
CHANGE:RADIO:SIDE BUTTON
Chan Slaved Auto
Scan
Dedicates Channel Selector position to turn Scan
On/Off
CHANGE:CHANNEL: OPT
Scan Programming
Alert
Enables tone when entering/exiting Scan
programming
CHANGE:RADIO:ALERT TONE
CONFIG
Priority Chan Lock
Alert
Enables tone when activity detected on Priority
Channel
CHANGE:RADIO:ALERT TONE
CONFIG