Getting Started 1 - 3
Setting Up the Scanner
Installing the Interface Cable
1. Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle.
(See Figure 1-2.)
2. Gently tug the cable to ensure the connector is properly secured.
3. Connect the other end of the interface cable to the host (see the specific host chapter for information on host
connections).
Figure 1-2
Installing the Cable
Interface Cable
Modular Connector
To host
Cable Interface Port
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Your connectors may be different than those illustrated, but the steps to connect the scanner are the
same.
To Next Page
Loading...
