Advanced Data Formatting 14 - 23
Setup Field(s)
Table 14-1
Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan
Move Cursor To Character
, then any printable ASCII
character from the
Alphanumeric Keyboard
. This moves the
cursor to the position after the matching character. If the
character is not there, the rule fails and ADF tries the next rule.
14-24
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the data.
14-24
Move Cursor Past a Character This action moves the cursor past all sequential occurrences of
a selected character. For example, if the selected character is
‘A’, then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan
Move
Cursor Past Character
, then select a character from the
Alphanumeric Keyboard
. If the character is not there, the
cursor does not move (i.e., has no effect).
14-24
Skip Ahead “N” Characters Scan one of these bar codes to select the number of positions
ahead to move the cursor.
14-25
Skip Back “N” Characters Scan one of these bar codes to select the number of positions
back to move the cursor.
14-26
Send Preset Value Send Values 1 through 6 by scanning the appropriate bar
code. Set these values using the prefix/suffix values in
Table
6-4 on page 6-22
.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
14-27
To Next Page
Loading...
