Maintenance and Technical Specifications 3 - 3
Scanned data is incorrectly
displayed on the host.
Scanner is not programmed to
work with the host. Check
scanner host type parameters
or editing options.
Be sure proper host is selected. (See the
host chapter for your scanner.)
For RS-232, ensure the scanner’s
communication parameters match the host’s
settings.
For a USB HID keyboard or a keyboard
wedge configuration, ensure the system is
programmed for the correct keyboard type
and language, and the CAPS LOCK key is in
the correct state.
Be sure editing options (e.g., ADF, UPC-E to
UPC-A Conversion) are properly
programmed.
Table 3-1
Troubleshooting (continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the symbol still does not scan, contact your distributor or Motorola
Enterprise Mobility Support. See page xv for contact information.
To Next Page
Loading...
