When the radio exits the mode:
• An alert tone sounds.
• The yellow LED turns off.
Scan Lists
Scan lists are created and assigned to individual channels
or groups. Your radio scans for voice activity by cycling
through the channel or group sequence specified in the
scan list for the current channel or group.
Your radio can support up to 250 scan lists, with a
maximum of 16 members in a list.
Each scan list supports a mixture of both analog and digital
entries.
Scan
Your radio cycles through the programmed scan list for the
current channel looking for voice activity when you start a
scan.
During a dual-mode scan, if you are on a digital channel,
and your radio locks onto an analog channel, it
automatically switches from digital mode to analog mode
for the duration of the call. This is also true for the reverse.
There are two ways of initiating scan:
Main Channel Scan (Manual)
Your radio scans all the channels or groups in your
scan list. On entering scan, your radio may, depending
on the settings, automatically start on the last scanned
active channel or group, or on the channel where scan
was initiated.
Auto Scan (Automatic)
Your radio automatically starts scanning when you
select a channel or group that has Auto Scan enabled.
NOTICE:
When you configure Receive Group Message In
Scan, your radio is able to receive group messages
from non-home channels. Your radio is able to reply
the group messages on home channel but is not
able to reply on non-home channels. Check with
your dealer or system administrator for more
information.
Turning Scan On or Off
Follow the procedure to turn scan on or off on your radio.
English
38 Send Feedback
To Next Page
Loading...