3 Do one of the following:
• Press the PTT button to transmit again.
• Press the Emergency Off button to exit the
Emergency mode.
NOTICE:
If your radio is set to Silent with Voice, it will
not display any audio or visual indicators
during Emergency mode when you are
making the call with hot mic, but allow sound
through the speaker when the target radio
responds after the programmed hot mic
transmission period is over.
The indicators will only appear when you
press the PTT button.
Reinitiating Emergency Mode
This feature is only applicable to the radio sending the
Emergency Alarm. Follow the procedure to reinitiate
Emergency mode on your radio.
Do one of the following:
• Change the channel while the radio is in
Emergency mode. The radio exits the Emergency
mode, and reinitiates Emergency, if Emergency
Alarm is enabled on the new channel.
• Press the programmed Emergency On button
during an Emergency initiation or transmission
state. The radio exits this state, and reinitiates
Emergency.
Exiting Emergency Mode
This feature is only applicable to the radio sending the
Emergency Alarm.
Your radio exits Emergency mode when:
• An acknowledgment is received (for Emergency Alarm
only).
•
An Emergency Exit Telegram is received.
• All retries to send the alarm have been exhausted.
NOTICE:
Your radio does not reinitiate the Emergency mode
automatically when it is powered up again.
Follow the procedure to exit Emergency mode on your
radio.
Do one of the following:
English
44 Send Feedback
To Next Page
Loading...