Receiving Emergency Alarms
Follow the procedure to receive Emergency Alarms on your
radio.
When you receive an Emergency Alarm:
• A tone sounds.
• The red LED blinks.
You can silence the tone. Do one of the following:
• Press the PTT button to call the group of radios which
received the Emergency Alarm.
• Press any programmable button.
• Exit Emergency mode.
NOTICE:
Your radio automatically acknowledges the
Emergency Alarm (if enabled).
Sending Emergency Alarms
This feature allows you to send an Emergency Alarm, a
non-voice signal, which triggers an alert indication on a
group of radios. Your radio does not display any audio or
visual indicators during Emergency mode when it is set to
Silent.
Follow the procedure to send Emergency Alarms on your
radio.
1 Press the programmed Emergency On button or the
Emergency footswitch.
2 Wait for acknowledgment.
If successful:
• The Emergency tone sounds.
• The red LED blinks.
If unsuccessful after all retries have been exhausted:
• A low-pitched tone sounds.
The radio exits the Emergency Alarm mode.
Emergency Alarms with Voice to
Follow
This feature allows you to send an Emergency Alarm with
Voice to Follow to a group of radios. Your radio microphone
is automatically activated, allowing you to communicate
English
42 Send Feedback
To Next Page
Loading...