programmed period, whenever the microphone on the
VOX-capable accessory detects voice.
The microphone source must be preconfigured and the
VOX-capable accessory attached to the preconfigured port.
NOTICE:
The radio may need to be turned off and powered
up again after detaching the VOX-capable
microphone to allow the radio to switch to another
valid accessory.
You can enable or disable VOX by doing one of the
following:
• Turn the radio off and then power it on again to enable
VOX.
• Change the channel by using the Channel Up/Down
buttons to enable VOX.
• Press the PTT button during radio operation to disable
VOX.
NOTICE:
Turning this feature on or off is limited to radios with
this function enabled. Check with your dealer or
system administrator for more information.
Turning Voice Operating Transmission
On or Off
Follow the procedure to turn VOX on or off on your radio.
Press the programmed VOX button to toggle the
feature on or off.
NOTICE:
If the Talk Permit Tone is enabled, use a trigger
word to initiate the call. Wait for the Talk Permit
Tone to finish before speaking clearly into the
microphone. See Turning Talk Permit Tone On or
Off for more information.
Turning Voice Announcement On or
Off
This feature enables the radio to audibly indicate the
current zone or channel the user has just assigned, or the
programmable button the user has just pressed.
This is typically useful when the user has difficulty reading
the content shown on the display.
English
Send Feedback 51
To Next Page
Loading...