Motorola MOTOTRBO SL1600 - Selective Calls; Responding to Selective Calls; Making Selective Calls; Select a channel with the active subscriber alias or ID.

Transceiver Performance Testing Test Mode 3-3
Figure 3-2. Channel Profile Screen Icon
3. A short press of the Side Programmable Button changes the Test Environment from
CSQ –> TPL –> DIG –> USQ –> CSQ.
- The radio beeps once for CSQ mode
- The radio beeps twice for TPL mode
- The radio beeps three times for DIG mode
- The radio beeps four times for USQ mode
4. Press the Volume +/– Button, to select a channel. The radio beeps at each position during
channel selection. Refer to Table 3-3 for Test Frequencies.
- Channel 1 to channel 8 is for TX Low Power
- Channel 9 to channel 16 is for TX High Power
5. Sway the Rocker to change between 12.5 kHz, 20 kHz and 25 kHz.
- The radio beeps once for 20 kHz
- The radio beeps twice for 25 kHz
- The radio beeps three times for 12.5 kHz
Table 3-2. Test Environments
No. of Beeps Description Function
1 Carrier Squelch (CSQ) RX: If Carrier is detected
TX: Mic Audio
2 Tone Private-Line (TPL) RX: Unsquelch if Carrier and Tone are detected
TX: Mix Audio + Tone
3 Digital Mode (DIG) RX: If Carrier is detected
TX: Mic Audio
4 Unsquelch (USQ) RX: Constant unsquelch
TX: Mic Audio
CH1
12.5 kHz
CSQ
(First character)
(Second and third character)
(Fourth character)