Motorola MTP3150

4.8.2.2
Setting Talkgroups in the Active Scan List
When and where to use:If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Active List.
NOTICE: If Scanning is Off is displayed, go to Group
Setup→Scan→Scanning→On to enable scanning.
3 Select View and highlight the required talkgroup.
4 Press Menu.
5 Select one of the following options:
• Delete – Erases this group from the active scan list.
• Priority and select new priority to Low, Medium or High.
4.8.2.3
Setting Scan Lists
When and where to use:If you want to set up any scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Scan Lists.
3 Highlight required scan list and press Menu to see additional settings:
• Rename – Enters new name for that scan list.
• Capacity – Displays the number of assigned and unassigned talkgroups for the scan list.
• Clear – Deletes all the talkgroup assigned to that scan list.
• Add Group – Adds a talkgroup to the scan list. Select one talkgroup from your talkgroup
folders and assign appropriate priority.
• Edit – Changes the priority of the required talkgroup or deletes it.
4.8.2.4
Deleting Talkgroups from Scan Lists
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Scan→Scan Lists.
3 Highlight the required scan list and press Menu→Edit.
4 Highlight the required talkgroup and press Menu→Delete.
68015000797-EH
Chapter 4: Main Menu
103