3 Select On.
NOTICE: Your service provider can enable this feature.
4.15.2
Viewing Your Position
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Position.
3 Scroll to view the results about the last time your location was calculated.
NOTICE: To refresh your position:
• Select Position – The radio refreshes its position automatically.
• Press Refresh
4.15.3
Viewing Testpage
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Testpage.
3 Select one of the following options:
• Position – Displays detailed information on your radio current position: time, N (latitude), E
(longitude), H (height), Sats Used (a number of tracked satellites), B (bearing), HS
(horizontal speed), LC (level of confidence).
• Power – Displays detailed information on a particular satellite: PRN code, Status, Mode,
C/N (carrier-to-noise ratio).
• Version – Displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.15.4
Changing GNSS Accuracy
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Accuracy.
3 Select one of the following options:
• Medium (default) – Power consumption optimization is combined with less position accuracy.
• High – Better position accuracy is combined with less power consumption optimization.
NOTICE: If connected to an external charging device, the radio automatically enters the
High mode.
68015000797-EH
Chapter 4: Main Menu
114
To Next Page
Loading...
