Motorola P Series User Manual

Test Equipment 3-19
10.0 Test Equipment
Table 3-2 lists test equipment required to service the P Series Radios and other two-way radios.
Table 3-2 Recommended Test Equipment
Motorola Part
No.
Description Characteristics Application
R2600CNT Comms System
Analyzer
(non MPT)
This monitor will
substitute for items with
an asterisk *
Frequency/deviation meter
and signal generator for
wide-range troubleshooting
and alignment
R2680ANT Comms System
Analyzer
(MPT1327) to be
ordered with
RLN1022A (H/W)
RLN1023A (S/W)
This monitor will
substitute for items with
an asterisk *
Frequency/deviation meter
and signal generator for
wide-range troubleshooting
and alignment
*R1072 Digital Multimeter AC/DC voltage and current
measurements
*R1377 AC Voltmeter 100 mV to 300 V,
5Hz-1MHz, 10 Megohm
input impedance
Audio voltage
measurements
WADN4133 Delay
Oscilloscope
2 Channel 40 MHz
bandwidth,
5 mV/cm - 20 V/cm
Waveform measurements
R1440A
0180305F14
0180305F30
0180305F39
RLN4610A
T1013
Wattmeter,
Plug-in Element
Plug-in Element
Plug-in Element
Carry case
RF Dummy Load
Thruline 50-Ohm, ±5%
accuracy
10W, 25 - 60 MHz
10W, 100 - 250 MHz
10W, 200 - 500 MHz
Wattmeter and
6 elements
Transmitter power output
measurements
S1339 RF Millivolt Meter 100mV to 3 VRF,
10 kHz to 1.2 GHz
RF level measurements
S1348 220V Power
Supply
20V 5A Programmable

Motorola P Series Specifications

General

Brand	Motorola
Model	P Series
Category	Radio
Language	English