Getting Started 1 - 5
Mount Stand (Optional)
Attach the base of the scanner stand to a flat surface using two screws or double-sided tape.
Figure 1-5
Scanner Mount Stand
Screw Mount
1. Position the assembled base on a flat surface.
2. Screw one #10 wood screw into each screw-mount hole until the base of the stand is secure.
Tape Mount
1. Peel the paper liner off one side of each piece of tape and place the sticky surface over each of the three
rectangular tape holders.
2. Peel the paper liner off the exposed sides of each piece of tape and press the stand on a flat surface until it is
secure.
Configuring the Scanner
To configure the scanner, use the bar codes included in this manual, or the 123Scan
configuration program.
See Chapter 4, User Preferences and Chapter 8, Symbologies for information about programming the scanner
using bar code menus. Also see each host-specific chapter to set up a connection to a specific host type.
See Chapter 9, 123Scan to configure the scanner using this configuration program. A help file is available in the
program.
NOTE Screws and double-sided tape are not provided.
Two screw-mount holes
Rectangular tape holders (3 places)
(dimensions = 1” x 2”)
To Next Page
Loading...
Need help?
General
