Motorola Symbol LS1203 - Data Transmission Formatting Options

4 - 8 Symbol LS1203 Product Reference Guide
Prefix/Suffix Values
A prefix and/or suffix can be appended to scan data for use in data editing.
To set a value for a prefix or suffix:
1. Change the scan data format by scanning the appropriate Scan Data Transmission Format on page 4-8.
2. Scan the appropriate prefix/suffix bar code on page 4-8.
3. Scan a four-digit number (i.e., four bar codes from Appendix D, Numeric Bar Codes) that corresponds to that
value.
4. To correct an error or change a selection, scan Cancel on page D-3.
Scan Data Transmission Format
To change the scan data format, scan Scan Options and one of the following four bar codes corresponding to the
desired format:
• Data As Is
• <DATA> <SUFFIX>
• <PREFIX> <DATA>
• <PREFIX> <DATA> <SUFFIX>.
Scan Enter on page 4-9 to complete the change. To set values for the prefix and/or suffix, see Prefix/Suffix Values
on page 4-8. Scan Data Format Cancel on page 4-9 to cancel the change.
If a carriage return/enter is required after each scanned bar code, scan the following bar codes in order:
1. Scan Options
2. <DATA> <SUFFIX>
3. Enter (on page 4-9).
NOTE When using host commands to set the prefix or suffix, set the key category parameter to 1, then set the
3-digit decimal value. See Table E-1 on page E-1 for the four-digit codes.
Scan Prefix
Scan Suffix