RS-232 Interface 6 - 3
RS-232 Parameter Defaults
Table 6-1 lists the defaults for RS-232 host parameters. If any option needs to be changed, scan the appropriate
bar code(s) provided in the Parameter Descriptions section beginning on page 6-4.
NOTE See Appendix A, Standard Defaults for all user preferences, hosts, symbologies, and miscellaneous
default parameters.
Table 6-1
RS-232 Defaults
Parameter Default Page Number
RS-232 Host Parameters
RS-232 Host Types Standard
6-6
Baud Rate 9600
6-7
Parity Type None
6-8
Stop Bit Select 1 Stop Bit
6-9
Data Bits (ASCII Format) 8-Bit
6-9
Check Receive Errors Enable
6-10
Hardware Handshaking None
6-10
Software Handshaking None
6-12
Host Serial Response Time-out 2 Sec
6-13
RTS Line State Low RTS
6-14
Beep on <BEL> Disable
6-14
Intercharacter Delay 0 msec
6-15
Nixdorf Beep/LED Options Normal Operation
6-16
Ignore Unknown Characters Send Bar Code
6-16
To Next Page
Loading...
