14 - 8 Symbol LS4278 Product Reference Guide
Special Commands
Pause Duration
Use this parameter, along with Send Pause on page 14-28, to insert a pause in the data transmission. Set the
pause by scanning a two-digit number (i.e., two bar codes) from Appendix D, Numeric Bar Codes in 0.1 second
intervals. For example, scanning bar codes 0 and 1 inserts a 0.1 second pause; 0 and 5 inserts a 0.5 second delay.
To correct an error or change a selection, scan Cancel on page D-3.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Save Rule
End of Message
14-96
a
-
z
14-96
{
-
~
14-100
Table 14-1
ADF Bar Codes (Continued)
Parameter
Page
Number
To Next Page
Loading...
