Motorola Symbol LS4278 - Battery Reconditioning LED Definitions; Inserting the Scanner in the Cradle; Horizontal Cradle Mount; Vertical Cradle Mount

Getting Started 1 - 11
Battery Reconditioning LED Definitions
Inserting the Scanner in the Cradle
Insert the scanner in the cradle so that the metal contacts on the bottom of the scanner handle touch the contacts
on the cradle. Push the handle lightly to ensure a proper connection, engaging the contacts in the cradle and
scanner. Ensure the desk/wall mount converter knob on the back of the cradle is in the correct position for the
horizontal or vertical mounting.
Horizontal Cradle Mount
When mounting the cradle horizontally, where no fastening is necessary:
1. Ensure the rubber feet are attached to the cradle. These feet provide traction and prevent surface damage.
2. Ensure the desk/wall mount converter knob is in the position shown in Figure 1-8.
Figure 1-8 Horizontal Mount - Inserting the Scanner in the Cradle
Vertical Cradle Mount
When mounting the cradle vertically:
1. Ensure the rubber feet are attached to the cradle. These feet provide traction and prevent surface damage.
2. Ensure the convertible mount hook on the front of the cradle is inserted with the hook facing up. If not, remove
and reverse the hook so that it is in position to secure the scanner in place. (See Figure 1-3 on page 1-4 for the
location of the convertible mount hook.)
Table 1-1 Battery Reconditioning LED Definitions
Battery Reconditioning
Mode
LED Comments
Discharging Red Flash Time to discharge is approximately 2.5 hours.
Charging Green Flash Time to charge is approximately 2.5 hours with an
external power supply.
Reconditioning Complete Green - Solid (always on) The scanner enters a trickle charge until the scanner is
removed from the cradle.
Desk/Wall Mount
Converter Knob