Motorola Symbol LS4278 - Setup Field(S)

Advanced Data Formatting 14 - 27
Setup Field(s)
Send Data (continued)
Send Next 19 Characters
Send Next 20 Characters
Table 14-2 Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character on page 14-28 , then any
printable ASCII character from the
Alphanumeric Keyboard on page
14-87
. This moves the cursor to the position after the matching
character. If the character is not there, the rule fails and ADF tries the
next rule.
14-28
Move Cursor to Start of Data Scan this bar code to move the cursor to the beginning of the data. 14-28
Move Cursor Past a Character This action moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan the
Move Cursor Past
Character on page 14-28
, then select a character from the
Alphanumeric Keyboard on page 14-87 . If the character is not there,
the cursor does not move (i.e., has no effect).
14-28
Skip Ahead “N” Characters Scan one of these bar codes to select the number of positions ahead
to move the cursor.
14-29
Skip Back “N” Characters Scan one of these bar codes to select the number of positions back to
move the cursor.
14-30
Send Preset Value Send Values 1 through 6 by scanning the appropriate bar code. Set
these values using the prefix/suffix values in
Table 7-4 on page 7-18 .
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
14-30