Scanning 2 - 7
Scanning with Intellistand
When the scanner is placed in Intellistand, the scan pattern selected in hand-held triggered mode continues (see
Scan Pattern on page 5-9).
To operate the scanner in Intellistand:
1. Ensure the scanner is set up to communicate with the cradle, and the cradle is properly connected to the host
and (see the appropriate host chapter for information on host connections).
2. Insert the scanner in Intellistand by placing the front of the scanner into the stand’s “cup.”
Figure 2-6
Inserting the Scanner in the Intellistand
3. Use the Intellistand’s adjustment knobs to adjust the height and angle of the scanner.
NOTE When the scanner is configured as a Master or Cradle Host and the Bluetooth connection to the remote
device is lost, the scanner must be removed from Intellistand and re-paired to the remote device. To
accomplish this, pull the trigger which engages the auto-reconnect feature, or scan the pairing bar code
for the remote device.
CAUTION When the scanner is not used for an extended period of time, place it in the cradle for charging. This
prolongs battery life symbol indicates that if this information is ignored, the possiblity of data or
material damage may occur.
Scanner Holder
Height Adjustment Knob
Angle Adjustment Knob
Cup
To Next Page
Loading...
