Motorola Symbol LS4278 - User Preferences Parameter Defaults

5 - 2 Symbol LS4278 Product Reference Guide
User Preferences Parameter Defaults
Table 5-1 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar
code(s) provided in the User Preferences section beginning on page 5-3.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 5-1 User Preferences Default Table
Parameter Default
Page
Number
User Preferences
Beeper Tone Medium 5-4
Beeper Volume High 5-4
Beep on Insertion Enabled 5-5
Power Mode Reduced Power Mode 5-7
Time Delay to Reduced Power Mode 1 sec 5-8
Intellistand Idle Timeout 15 min 5-5
Scan Pattern Multi-line Always Raster 5-9
Scan Line Width Full Width 5-10
Laser On Time 3.0 sec 5-10
Beep After Good Decode Enable 5-11
Transmit Code ID Character None 5-12
Prefix Value 7013 <CR><LF> 5-13
Suffix Value 7013 <CR><LF> 5-13
Scan Data Transmission Format Data as is 5-15
FN1 Substitution Values Set 5-15
Transmit “No Read” Message Disable 5-15
Synapse Interface Standard 5-16
Batch Mode Normal (Do Not Batch Data) 5-17