Maintenance, Troubleshooting & Technical Specifications 3 - 3
Scanner emits long low/long high
beeps.
Input error, incorrect bar code or
Cancel
bar code was scanned.
Scan the correct numeric bar codes
within range for the parameter
programmed.
Page timeout; remote device is
out of range/not powered.
Move the scanner back into range of
the remote device; try to re-connect;
check remote device configuration.
Scanner emits long low/long
high/long low/long high beeps.
Out of host parameter storage
space.
Scan
Default Parameters on page
5-3
.
Out of memory for ADF rules. Reduce the number of ADF rules or the
number of steps in the ADF rules.
Connection attempt was rejected
by remote device.
Free up remote device resources.
Scanner emits high/high/high/low
beeps.
RS-232 receive error. Normal during host reset. Otherwise,
set the scanner's RS-232 parity to
match the host setting.
Scanner emits high/low beeps. The scanner is buffering Code 39
data.
Or
Keyboard parameter selected.
Normal.
Or
Enter value using bar code keypad.
Bluetooth disconnection event. Move the scanner back into range of
the remote device.
In Master (SPP) mode, re-pair the
scanner and cradle by scanning the
PAIR
bar code on the cradle; check
cradle power.
In Slave (SPP/HID) mode, reestablish
connection between the scanner and
remote device from the remote device
side.
Scanner emits three long high
beeps.
Code 39 buffer is full. Scan the Code 39 bar code without a
leading space or scan
Do Not Buffer
Code 39
on
page 13-28
to transmit
stored Code 29 data.
Scanner emits four high beeps on
trigger release.
Low battery. Place scanner in cradle to charge the
battery.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
To Next Page
Loading...
