Motorola TC55 - Configuring the Device to Use a Static IP Address; Figure 96: Proxy Settings; Figure 97: Static IP Settings

3 Touch Proxy settings and select Manual.
Figure 96: Proxy Settings
4 In the Proxy hostname text box, enter the address of the proxy server.
5 In the Proxy port text box, enter the port number for the proxy server.
Note: When entering proxy addresses the Bypass proxy for field, do not use spaces or carriage returns
between addresses.
6 In the Bypass proxy for text box, enter addresses for web sites that do not require to go through the proxy server.
Use the separator “|” between addresses.
7 Touch Connect.
8
Touch
.
Configuring the Device to Use a Static IP Address
By default, the device is configured to use Dynamic Host Configuration Protocol (DHCP) to assign an Internet
protocol (IP) address when connecting to a wireless network. To configure the device to connect to a network using a
static IP address:
Procedure:
1 In the network dialog box, touch a network.
2 Touch Show advanced options checkbox.
3 Touch IP settings and select Static.
Figure 97: Static IP Settings
4 In the IP address text box, enter an IP address for the device.
116 | Wireless
September 2013 | MN000015A01