Motorola TC55 - Attaching the Stylus to the Protective Boot; Figure 124: Insert Tether into Stylus; Figure 125: Feed Stylus through Tether Loop

3 Ensure that the Protective Boot is properly fitted on the TC55.
Attaching the Stylus to the Protective Boot
Procedure:
1 Insert one end of the tether into the hole in the stylus.
Figure 124: Insert Tether into Stylus
2 Feed the other end of the tether through the first loop.
3 Pull the tether taut.
4 Feed the loose end of the tether through the tether hole in the Protective Boot.
Figure 125: Feed Stylus through Tether Loop
5 Feed the stylus through the tether loop.
6 Pull the tether taut.
7 Insert the point of the stylus into the mounting hole in the boot.
Accessories | 143
MN000015A01 | September 2013