Motorola TC55 - Advanced Wi-Fi Settings; Modifying a Wi-Fi Network; WLAN Configuration

5 If required, in the Gateway text box, enter a gateway address for the device.
6 If required, in the Network prefix length text box, enter a the prefix length.
7 If required, in the DNS 1 text box, enter a Domain Name System (DNS) address.
8 If required, in the DNS 2 text box, enter a DNS address.
9 Touch Connect.
10
Touch
.
Advanced Wi-Fi Settings
Note: Advanced Wi-Fi settings are for the device not for a specific wireless network.
Use the Advanced settings to configure additional Wi-Fi settings. From the Wi-Fi screen, touch > Advanced to
view the advanced settings.
• General
- Network notification - When enabled, notifies the user when an open network is available.
- Keep Wi-Fi on during sleep - Opens a menu to set whether and when the Wi-Fi radio turns off.
+ Always (increases data usage) - The radio stays on when the device enters suspend mode.
+ Only when plugged in - The radio stays on while the device is connected to external power.
+ Never - The radio turns off when the device enters suspend mode (default).
- MAC address - Displays the Media Access Control (MAC) address of the device when connecting to Wi-Fi
networks.
- IP address - Displays the IP address of the device when connecting to Wi-Fi networks.
WLAN Configuration
Use the WLAN Configuration settings to configure additional WLAN settings. From the Wi-Fi screen, touch
>
WLAN Configuration to view the settings.
• Country Override - Check to disable 802.11d. Select the country of operation from the menu.
• Rate Selection
- Auto Mode (a/b/g/n) - Use all data rates available (default).
- 11a/b/g Only - Use only 802.11 a/b/g.
- 11n mode Only - Use only 802.11n.
• Band Selection
- Auto (2.4GHz and 5GHz) - Use both the 2.4 GHz and 5 GHz bands (default).
- 2.4Ghz Only - Use only the 2.4 GHz band.
- 5Ghz Only - Use only the 5 GHz band.
• Enable Power Saving - When enabled, the WLAN radio goes into sleep mode when there is no WLAN activity.
Modifying a Wi-Fi Network
The user can change settings and passwords for a network in the Wi-Fi list.
Procedure:
1
Touch .
2
Touch
.
3
Touch Wi-Fi.
4 Slide the Wi-Fi switch to the On position.
5 Touch and hold on a network name and then touch Modify network.
Wireless | 117
MN000015A01 | September 2013