4.16.4
Backlog
This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTE: The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.16.4.1
Enabling or Disabling Backlog
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Backlog→Enablement.
3 Select one of the following options:
• On – Activates location report backlog recording.
• Off – Deactivates location report backlog recording.
4.16.4.2
Viewing Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Backlog→Reports.
The radio displays the number of backlog reports stored.
4.16.4.3
Deleting All Backlog Reports
Procedure:
1 From the home screen, press the Menu key.
2 Select Location→Backlog→Delete All.
4.17
Packet Data
NOTE: This is a Software Selling Feature.
The Packet Data (PD) Service allows you to transfer data in a TETRA system using the Internet
Protocol (IP).
NOTE:
To transfer data from a standard computer over the air, connect the computer using the data
cable PMKN4104 with your radio. Your service provider has to setup additional applications on
your computer.
If set up by your service provider it is possible to accelerate the transmission by using the Multi-Slot
Packet Data (MSPD) Service.
68015000180-MR
Chapter 4 : Main Menu
121
To Next Page
Loading...
Need help?
General