6809497A15-A January 31, 2006 35
Level 1 and 2 Service Manual Disassembly
9. Insert the disassembly tool between the flip assembly and the flip housing to
release the 3 latches on each side of the flip assembly (see Figure 17).
10. Carefully lift the flip cover away from the flip assembly. Avoid damaging the
display flex cable and connector.
11. To replace, align the flip cover with the flip assembly. Press the flip cover onto
the flip assembly until the 6 latches are fully engaged.
12. Insert and tighten the 4 flip screws with the T5 driver to a final torque setting
of 0.6 in.-lbs. Do not overtighten.
13. Remove the adhesive from the back of the new display lens and apply lens to
the flip housing.
14. Replace the flip assembly, keypad assembly, transceiver board assembly, rear
housing, antenna, SIM, battery, and battery cover as described in the
procedures.
040958o
Figure 21. Removing the Display Lens
Flip Housing Catch
Flip Assembly
Flip Housing Catch
Flip Housing
Catch
To Next Page
Loading...
