6809471A72-O April 14, 2004 27
Level 1 and 2 Service Manual Disassembly
3. Gently lift the transceiver board and carefully pass the flex connector through
the opening in the transceiver board (See Figure 11).
4. After the flex connector is clear of the transceiver board, lift the transceiver
board assembly from the phone.
5. To replace, align the transceiver board assembly with the phone housing.
6. Insert the flex connector through the opening in the transceiver board
assembly.
7. Lower the transceiver board assembly onto the housing.
8. Coil the flex assembly in a clockwise direction.
9. Insert the flex connector squarely into its mating connector on the transceiver
board and press firmly until it snaps into place.
10. Replace the rear housing assembly, antenna housing, SIM, battery, and
battery cover as described in the procedures.
040175o
Figure 11. Removing the Transceiver Board
Tramsceiver PC
Board
Display Flex
Connector
To Next Page
Loading...
