INSTALLING THE 4PRE HARDWARE
25
A TYPICAL 4PRE SETUP
Here is a typical 4pre studio setup. In this example,
no external mixer is needed. All mixing and
processing can be done in the computer with audio
software, or you can use the 4pre’s CueMix™ no-
latency mixer. You can control the 4pre’s four
separate mixes from the front panel or from the
included CueMix FX software.
S/PDIF
DAT deck
quarter-inch
analog outs
synthesizer
monitors
Figure 4-4: A typical 4pre studio setup.
headphones
4pre
rear panel
FireWire
or USB2
guitars
(with or without an amp)
PC
mics
(condenser or dynamic)
4pre
front panel
headphones
(Alternatively, instead of mics)
To Next Page
Loading...
