Movado BOLD Evolution Day Date - Page 29

29
5. Pull crown out to position 3; watch stops.
6. Turn crown counterclockwise until correct date
(23) appears in window D and correct day of
week (THU) is indicated by subdial hand F.
7. Continue to turn crown counterclockwise until
hour and minute hands indicate correct time (8:35
PM), being sure to take AM/PM time into account.
8. Push crown back in to position 1, and screw back
down into case.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons A and B to operate the chronograph.
Pressing button A the first time will start the
chronograph. Pressing button A a second time will
stop the chronograph, allowing elapsed time to
be read. Pressing button A a third time will restart
the chronograph. Pressing button B will reset
chronograph hands C and E to zero. Adjusting the
time does not stop the chronograph, but it does
block buttons A and B for as long as the crown is
pulled out.
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press
button B to reset hands to zero.
IMPORTANT: Do not push button A or B when
crown is pulled out to position 2 or 3. If button A or
B is accidentally activated while crown is not flush
against case, one or more of the chronograph
hands may become de-synchronized. Should this
occur, follow instructions at end for synchronizing
chronograph hands.
Simple chronograph functions:
To measure the duration of a single, non-stop
event:
1. Press button A to start chronograph.
2. Press button A a second time to stop
chronograph, and read the 2 chronograph hands
to determine elapsed time, for example: 20
minutes, 38 seconds.
3. Press button B to reset chronograph hands to
zero.
Accumulated time functions:
To measure the combined time of a series of
shorter events, for example the actual playing
time of a football game, where play is repeatedly
interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph
and read elapsed time, for example: 15 minutes,
5 seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example:
20 minutes, 17 seconds.
NOTE: Each time you stop chronograph,
chronograph hands will indicate total accumulated
time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button B to reset chronograph
hands to zero.
Split-time or intermediate-time functions:
To take intermediate time readings as a race
progresses:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example:
20 minutes, 17 seconds.
4. Press button B to resume chronograph function.
The 2 chronograph hands will quickly catch up
with ongoing event.
12
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE C
Includes Movado Heritage Series Calendoplan chronograph models