30
5. To read a second split time, press button B again.
Repeat steps 2 through 4 to take any additional
split times.
6. Press button A to stop chronograph.
7. Take a reading of the final time, for example:
29 minutes, 7 seconds.
8. Press button B to reset chronograph hands to
zero.
Synchronizing chronograph hands:
After a battery change or in the event of an error,
you may need to manually adjust one or both of the
chronograph hands to align them correctly at their
zero positions.
NOTES: Once in corrective mode, each press and
release on push-button A will advance active
chronograph hand by one increment. To advance
hand rapidly, depress and hold push-button A.
You may exit correction mode at any time in the
sequence by returning crown to position 1.
1. Pull crown out to position 3.
2. Press and hold push-buttons A and B
simultaneously for at least 2 seconds to enter
corrective mode. When chronograph seconds
hand C rotates 360
o
, corrective mode is
activated; release buttons A and B.
3. Adjust center-mounted chronograph seconds
hand C using push-button A.
4. When hand C reaches zero position, press push-
button B.
5. Now press push-button A to adjust minute
counter hand E.
6. When hand E reaches zero position, press push-
button B.
7. Push crown back in to position 1.
Timing hands are now synchronized at zero
position, and chronograph is ready for use.
12
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE C
Includes Movado Heritage Series Calendoplan chronograph models
To Next Page
Loading...
