28
Boundary signal error
If the boundary signal is not operating correctly - for example, the Robotic Mower is outside the working area,
the boundary wire is incorrectly connected or is damaged, or if there is no power supply, the Robotic Mower will
turn in circles searching for the boundary signal and will finally stop; the screen will display the information
boundary signal error.
Please make sure the Robotic Mower is in the working area and check if the LED indicator on the charging
station is constantly green. Please check the LED as follows:
LED off ► no power supply.
LED flashing green ► boundary wire is cut or
► wire incorrectly connected or
► wire loose from the charging station’s connectors
Please see section trouble shooting 7.2 No. 11.
Main board error
The mower is controlled by a main PCB board, with a programmed MCU, a gyroscope and other components. If
certain components error or fail, the screen will display the information Main board error.
Please try to restart the mower. If the problems persist, please contact the service centre.
Please note: It is important to check and follow the instructions outlined in this manual completely.
Incorrect maintenance or installations are not covered by the warranty.
To Next Page
Loading...