27
Mower lifted:
If the lift sensors are activated continuously for ten seconds, the Robotic Mower will stop and display the
information “Mower lifted”. Please open the LCD cover and hit
to restart the robotic mower.
If this error message shows frequently, please check if there are obstacles taller than 100 mm in the working
area and move these obstacles out of the working area or change the boundary wire layout to exclude these
objects.
Please note: This fault may be caused by the grass being too high in the working area; please cut the grass to
less than 60 mm.
Please see section trouble shooting 7.2 No. 3.
Mower rolling over or Mower tilted
If the Robotic Mower is turned over (upside down), or has been tilted over 35%(20゜) for a period of time, the
Robotic Mower will stop and display information: “Mower rolling over” or “Mower tilted”. Please turn the Robotic
Mower back to its normal position, open the LCD cover and hit
to restart.
If the rolling over is caused by a steep slope in the working area, please change the boundary wire layout to
avoid the slope.
Please see section trouble shooting 7.2 No. 4.
Motor over-current
The motors are protected against current overloading. Please open the LCD cover and hit
to restart the
Robotic Mower.
If this error message appears frequently, please check the grass height in the working area and cut it to less
than 60 mm. Please also inspect the blade disk and the wheels for thick mud, leaves and, if needed, clean the
parts thoroughly.
Please see section trouble shooting 7.2 No. 5.
Motor Fault
If the system detects a potential motor issue, the Robotic Mower will stop and display the message: “Motor fault”.
Please check the rear wheels and the cutting disk, clear and clean any obstructions and restart the mower.
Wear safety gloves. If the fault continues, please contact the service centre.
Please see section trouble shooting 7.2 No. 5.
Battery low voltage
Please carry the Robotic Mower to the station for charging and put it in the charging position.
Please see section trouble shooting 7.2 No. 6.
Battery error
In this case the battery has reached its end of life
Please see section trouble shooting 7.2 No. 7.
Battery temperature abnormal
The battery temperature range for discharging is 0 to 75℃, for charging is 0 to 45℃. Out of this range, the
Robotic Mower returns to the charging station and waits to cool down or warm up. The screen then displays
battery temperature abnormal.
High ambient temperatures over 35℃, strong sunlight or very cold conditions will cause this message.
During summertime, it is recommended to change the work time to the early morning hours. During wintertime,
store the Robotic Mower in a warm area – this may be in the house or heated garage. The local service centre
may offer a winter storage or maintenance service.
Please see section trouble shooting 7.2 No. 8.
PCB over temperature
If the PCB (main board) in the Robotic Mower is over 90℃, the Robotic Mower will stop cutting, go back to the
station and wait for it to cool down.
High ambient temperatures over 35℃ or strong sunlight may cause this.
You are recommended to change the work time to the early morning hours to avoid the warmer times of the day.
Please see section trouble shooting 7.2 No. 9.
Hall error
There are four magnets in the upper cover of the Robotic Mower. If the screen displays: Hall error, please check
if there are metal parts between the magnets and the deck. Take off the metal parts if needed.
Please see section trouble shooting 7.2 No. 10.
To Next Page
Loading...