MOWBOT MOWBOT800 - Page 34

32
6
The Mower
has
stopped
and
the screen
is off.
Battery low
voltage
Battery voltage
is too low and
not on the
charging
station, the
Mower will stop
and the display
will be blank.
Carry the Robotic Mower to the station for charging.
7
The
Robotic
Mower
cannot
start or the
battery
cannot be
charged.
Battery
error
The battery may
require attention
or replacement.
Check or replace the battery.
8
During the
set working
time, the
Robotic
Mower
goes back
to the
station, or
the battery
cannot be
charged on
the
charging
station.
Battery
temperature
abnormal
1. If the battery
temp. is higher
than 75℃, the
Robotic Mower
will go back to
or stay on the
charging
station.
2. If the battery
temp. is higher
than 45℃ or
lower than 0℃,
it will stop
charging and
wait on the
base.
1. In the summer, please set the working time to the
early morning; try to avoid the Robotic Mower working
during hot daytime temperatures.
2. After having cooled down to the rated range
(charge: 0-45℃; discharge: 0-90℃), the Robotic
Mower will automatically return to the set program.
9
The Mower
goes back
to the
station and
stays there
during its
designated
working
time.
PCB over
temperature
If the PCB is
overheated, the
program will
send the
Robotic Mower
back to the
station to wait
for the mower to
cool down.
1. In summer season, please set the working time to
the early morning; try to avoid the Robotic Mower
working during hot daytime temperatures.
2. After the PCB has cooled down, the Robotic Mower
automatically returns to the designated schedule.
10
The Mower
cannot pass
its program
self check,
cannot be
started
Hall error
There are metal
parts between
the magnets
and the deck.
Take off the metal parts if needed. Take the mower to
a service dealer.
11
The Mower
turns in
circles and
then stops
Boundary
signal error
The Robotic
Mower is
outside the
working area.
The boundary
wire has a fault.
There is no
power supply.
1. Make sure the Robotic Mower is in the working
area.
2. Check if the LED indicator on the charging station is
constantly green.
3. If the Robotic Mower runs outside of the boundary
frequently, please check if there is a high-voltage cable
nearby or underneath. Change the position of the
boundary wire.
4. If the Robotic Mower runs outside of the boundary
on a slope, avoid that area by changing the position of
the boundary wire.
5. Restart the Robotic Mower or take it to the charging
station.