33
12
Screen is
off
None
Hit the Power
key on the key
board for 3 sec.
to turn the LCD
screen on.
If the battery
voltage is too
low, the LCD
screen cannot
be turned on.
Electric circuit
or electronic
parts problems
may also cause
this problem, if
this occurs,
please contact
the service
centre.
1. Make sure the main power switch is “ON”.
2. When you first use the Robotic Mower the battery
may not be fully charged. Put the Robotic Mower into
its charging station.
3. For normal working, press the power key on control
panel, then input the PIN and start the Robotic Mower.
4. If the screen is still off, please carry the Robotic
Mower to the charge station. Make sure the main
switch is “ON” for the battery to be charged.
5. If the problem persists contact the service centre.
13
The Mower
cannot
enter the
charging
station
None
If the charging
station is not
installed
correctly, the
Robotic Mower
cannot enter it.
1. Make sure the LED indicator on the charging station
is constantly green.
2. Check if the boundary wire is under and in front of
the charging station and are aligned.
3. Check if the charging station is positioned correctly.
4. Ensure charging station installation is level.
14
turns
around in
circles
along the
boundary
wire.
None
cable close to
the Boundary
wire or
underneath it
affects the
Check if there is a high-power cable close to the
boundary wire or underneath it; change the position of
the boundary wire to avoid this.
15
Robotic
Mower
stopped
while
running
back to the
station.
None
boundary wire
blocked the
mower’s
movement.
Remove any obstacle on the boundary.
16
behaves
abnormally
around
islands
(flower
beds, pool,
etc.)
None
Boundary wire
incorrectly
placed around
the islands
Relocate the boundary wire
To Next Page
Loading...