Moxa Technologies MGate MB3000 Series - Serial Communication Parameters

MGate MB3000 User’s Manual Configuring the Modbus Gateway
9-16
Configure Serial Communication Parameters
The Serial tab is where each serial port’s communication parameters are configured. You can
configure Baud Rate, Parity, Stop Bit, Flow Control, FIFO, and Interface Mode.
Parameter
Value
Interface Mode
RS-232
RS-422
RS-485, 2W
RS-485, 4W
Baud Rate
50 bps to 961200 bps
Parity
None, Odd, Even, Space, Mark
Stop Bits
1, 2
Flow Control
None, Xon/Xoff, RTS/CTS
UART FIFO
Enable, Disable