MP FONOMAC 3 - Other Parameterisation Methods; Parameterisation via MP Console; Local Parameterisation via PC; Remote Parameterisation via PC

PRODUCT TECHNICAL MANUAL
FONOMAC 3
V2.20 – 06/2012
18
MTELFONOMAC3220_EN
Fonomac 3 will indicate the programming progress using the following sounds:
 Short Beep: It indicates that the key pressed belongs to one of the accepted commands.
 Long Beep: It indicates that the key pressed does not correspond to any recognised command and,
therefore, the sequence of keys pressed so far will be reset. This sound will also be heard if the command is
not accepted or if the value entered is out of range.
 Multitone: It indicates that the command entered has been correctly executed.
To exit programming mode, press key P again; Fonomac 3 will exit programming mode, reset and load the new
parameters entered by the user.
Aside from parameterisation, other commands can be executed with the keypad:
 TEL <Alarm No.>: It makes an alarm call to the selected <alarm No.> once programming mode has been
exited. Exemple: TEL 1 => trigger a call to the alarm 1 telephone.
 TEST : It makes a test call once programming mode has been exited.
 SPCH: The SPCH Key is used to record/play voice messages (please refer to chapter 7. VOICE MESSAGES
for further information)
 TEL*: It loads the default parameter profile.
 TEL #: Reset of Statistics.
NOTE: Always make sure the equipment is connected to an external power source when you make the
parametrisation; if Fonomac 3 is exclusively feeded by its internal battery, the modified parameters will not be
permanently recorded.
2.4. Parameterisation via MP Console
The Fonomac 3 telephone incorporates a MP Console-compatible CAN-Bus communication port (Via Series
controller). The terminal can be parameterised without entering the programming mode and at any time during
operation.
Please refer to Appendix: Console Programming Manual for further information on parameterisation in this mode.
2.5. Local parameterisation via PC
Fonomac 3 is HEA tool kit compatible. The equipment can be parameterised using the HEA-INTERCOM board and
the HEA PC tool (only for Windows XP and Windows 7).
Please refer to User Manual: MP Telephone Remote Parameterisation via Software (MTSWPROGTELMPxxx), for
further information on parameterisation in this mode.
2.6. Remote Parameterisation via PC
Fonomac 3 is compatible with the “Remote parameterisation Software for MP telephones” (only for Windows XP
and Windows 7).
Please refer to User Manual: User Manual: HEA tools 2011 (MTSWPCHEA2011xxx), for further information on
parameterisation in this mode.