PRODUCT TECHNICAL MANUAL
FONOMAC 3
V2.20 – 06/2012
29
MTELFONOMAC3220_EN
7. VOICE MESSAGES
7.1. General considerations
Fonomac 3+ incorporates the function of playing voice messages during the calling process.
It has 7 voice messages, reprogrammable by the user, which will provide the receiver with data such as the
reason for the call, location of lift, etc.
MESSAGE
NUMBER
MAX. DURATION
(in seconds)
DESCRIPTION
1 4
Test Message. Played upon request once the alarm has been accepted
by pressing key “4”.
2 4
Breakdown Message 1 (ES1 signal activation). Played upon request once
the alarm has been accepted by pressing key “4”.
3 4
Breakdown Message 2 (ES2 signal activation). Played upon request once
the alarm has been accepted by pressing key “4”.
4 4
Breakdown Message 3 (ES1 and ES2 signal simultaneous activation).
Played upon request once the alarm has been accepted by pressing key
“4”.
5 12
Reassurance Message. Played in the car once the alarm has been
triggered to inform the trapped users that the rescue process has
started.
6 12
Location Message. Played upon request once the alarm has been
accepted by pressing key “4”.
The location message indicates the building address where the lift is
located with the purpose of quickly locating the origin of the alarm call.
7 4
Low battery message. Played upon request once the alarm has been
accepted by pressing key “4”.
The low battery message informs the call receiver that the equipment’s
battery came into critical functioning zone and it has less than one hour
of life left.
After the messages (1, 2, 3, 4 and 7) have been played, the “Location Message” will be automatically played, in
order to locate immediately the call origin.
7.2. Message recording and reproduction
Fonomac 3+ does not include any pre-recorded messages. The corresponding messages to activate these
functions must be recorded.
Messages can be recorded in two ways:
Recording/Reproduction in local mode:
The user must access the programming mode by using the direct access key “P”.
o Press “SPCH (message no.) *” to access the recording of the “message no.” message”. Fonomac
3+ turns on the permanent green LED and the quickly flashing yellow one, thus indicating that the
call can be made. Using an external phone, call Fonomac 3+ which, when connected, will indicate
the beginning of message recording with a beep. Before the message time is up, Fonomac 3+ will
indicate the end of the message with another beep.
o Press “SPCH (message no.) *” to play the “message no.” message”. Fonomac 3+ will play the
message (message no.).
Recording/Reproduction in remote mode:
Remote message recording allows the user with no direct access to Fonomac 3+ to record voice messages by
using an external phone or the Fonomac 3+ remote Parameterisation Software.
Voice commands are accessed by using the following sequence of commands:
Call Fonomac 3+.
Select the lift number: # “lift number” 0
Send access code: * 1111 * (default code: 1111).
Commands to control voice messages:
#*(message no.)*: Request to record the “message no.” voice message. Fonomac 3+ will emit a beep
indicating the beginning of the message recording and another one to indicate its completion. If the
recording time is shorter than the maximum time, just dial the key 1 to indicate the recording is ended.
#*(message no.)#: Request to play the “message no.” voice message. Fonomac 3+ will play the selected
voice message.
N.B.: Should you have any doubt during the execution of these commands, dial the sequence *** to come back
to the beginning of the command introduction.
To Next Page
Loading...