© 2018 mPTech. All rights reserved. Hammer Energy
12
7.2 Installation of the memory card.
To insert the memory card correctly one has to:
• Switch off the phone,
• Use the supplied tool to open and slide out the card tray.
• Insert the memory card into the slot as shown in the picture below
(instead of the nanoSIM1 card).
Use only memory cards recommended by the manufacturer. Pay attention
to the selection of the proper format-the microSD card, capacity and type/class.
Incompatible memory cards may damage the device and cause the stored data
to be destroyed as well. Incompatibility of memory card can be caused, among
others, by an incorrect card format (required format microSD) or an unsupported
card capacity - above the value recommended by the manufacturer.
7.3 Charging the battery
Charge the battery before the first use. The battery should be charged by the
attached charger or another charger, intended for this type of equipment. If in
doubt contact the seller or manufacturer service. Use only chargers and wires
recommended by the manufacturer.
Using incompatible chargers or cables can cause explosion of the battery or
damage to your device. When the battery is near a complete discharge, the
notification is displayed on a low battery charge. To continue use of the device
To Next Page
Loading...
Need help?
General
