MRC SL-4035SD - Configuring Sampling Time; Auto Power Off Configuration

2) After set all the time value ( Year, Month, Date, Hour,
Minute, Second ),
the screen will jump to " SD card Decimal character "
setting screen ( Chapter 7-2 ).
Remark
:
After the time value is setting, the internal clock wil
l
run precisely even Power is off ( The battery is unde
r
normal condition, no low battery condition ).
7-2 Set sampling time ( seconds )
When the lower display show " SP-t "
1)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼ Button " (
3-6, Fig. 1 ) to adjust the value ( 0, 1, 2, 5, 10, 30,60,
120, 300, 600, 1800,3600 seconds ).
Remark
:
If select the sampling time to " 0 second ", it is ready
for manual Datalogger.
2)
After the Sampling value is selected, press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
function with default.
7-3 Auto power OFF managemen
t
When the lower display show " POFF "
1)
Use the " ▲ Button " ( 3-5, Fig. 1 ) or " ▼
Button "
( 3-6, Fig. 1 ) to select the upper value to " YES " or
" NO ".
YES - Auto Power Off management will enable.
NO - Auto Power Off management will disable.
2)
After select the upper text to " YES " or " NO ", press the
" Enter Button " ( 3-8, Fig. 1 ) will save the setting
function with default.
19