ALTAIR 2X
46
Maintenance
GB
(6) Ensure the interface and connectors for the display are clean and free of
dirt for proper operation.
If necessary, the display connectors can be cleaned with a soft, lint-free
cloth.
(7) Reinstall the screws.
(8) Calibrate the device.
4.4 Cleaning
Clean the exterior of the device regularly using only a damp cloth. Do not use
cleaning agents other than listed in section 7.
4.5 Storage
When not in use, store the device in a safe, dry place between 0 °C and 40 °C.
After storage, always recheck device calibration before use.
4.6 Scope of Delivery
Pack the device in its original shipping container with suitable padding. If the
original container is unavailable, an equivalent container may be substituted.
CAUTION
Do not over-tighten the screws; otherwise, the case may be damaged.
WARNING
Calibration is required after a sensor is installed; otherwise, the device will not
perform as expected and persons relying on this product for their safety could
sustain serious personal injury or death.
To Next Page
Loading...
