ALTAIR 2X
6
Safety Regulations
GB
1 Safety Regulations
1.1 Correct Use
The ALTAIR 2X gas detector, hereafter referred to as device, is intended for use
by trained and qualified personnel. It is designed to be used when performing a
hazard assessment to:
- Assess potential worker exposure to toxic gases and vapours.
- Determine the appropriate gas and vapour monitoring needed for a work-
place.
The ALTAIR 2X gas detector can be equipped for:
- Detecting specific toxic gases for which a sensor is installed
It is imperative that this operating manual be read and observed when using the
product. In particular, the safety instructions, as well as the information for the
use and operation of the product, must be carefully read and observed. Further-
more, the national regulations applicable in the user's country must be taken
into account for a safe use.
Alternative use, or use outside this specification will be considered as non-
compliance. This also applies especially to unauthorised alterations to the
product and to commissioning work that has not been carried out by MSA or
authorised persons.
WARNING
This product is supporting life and health. Inappropriate use, maintenance or
servicing may affect the function of the device and thereby seriously compro-
mise the user's life.
Before use the product operability must be verified. The product must not be
used if the function test is unsuccessful, it is damaged, a competent servicing/
maintenance has not been made, genuine MSA spare parts have not been
used.
To Next Page
Loading...
Need help?
General
