ALTAIR 2X
8
Safety Regulations
GB
Check Confidence Indicator
The Confidence indicator must flash every 15 seconds after starting the device.
Defective Vibrating Alarm Possible
At ambient temperatures < 0 °C, the vibrating alarm can give a false alarm or
can fail completely. In such conditions, do not rely solely on the vibrating alarm.
Physical Shock
Perform a calibration if device is subjected to physical shock.
Sensor Maintenance
Do not block sensor opening as this may cause inaccurate readings. Do not
press on the face of the sensor, as this may damage it and cause erroneous
readings. Do not use compressed air to clean the sensor holes, as the pressure
may damage the sensor.
Observe Proper Time for Display Stabilising
Allow sufficient time for device to display accurate reading. Response times
vary based on the type of sensor being utilized.
Be Aware of Environmental Conditions
A number of environmental factors may affect the sensor readings, including
changes in pressure, humidity and temperature.
Be Aware of the Procedures for Handling Electrostatically Sensitive
Electronics
The device contains electrostatically sensitive components. Do not open or
repair the device without using appropriate electrostatic discharge (ESD)
protection. The warranty does not cover damage caused by electrostatic
discharges.
Be Aware of the Product Regulations
Follow all relevant national regulations applicable in the country of use.
Be Aware of the Warranty Regulations
The warranties made by Mine Safety Appliances Company with respect to the
product are voided if the product is not used and maintained in accordance with
the instructions in this manual. Please protect yourself and others by following
them. We encourage our customers to write or call regarding this equipment
prior to use or for any additional information relative to use or service.
To Next Page
Loading...
