MSA fieldserver ProtoNode FPC-N64 - Page 29

60 pages

Save Page as PDF

To Next Page

To Previous Page

NOTE:For additional FieldServer Manager instructions see the MSA Grid - FieldServer Manager Start-up Guide.

29 Hunter Fans ProtoNode FPC-N64

Main Page

Table of Contents4
Introduction6
Protonode Gateway6
Setup for Protonode7
Record Identification Data7
Point Count Capacity and Registers Per Device7
Configuring Device Communications7
Set Node-ID for any Device Attached to the Protonode7
Set IP Address for any Ethernet Device Connected to the Protonode7
Interfacing Protonode to Devices8
Device Connections to Protonode8
Wiring Field Port to RS-485 Serial Network8
Bias Resistors9
Termination Resistor10
Power up the Gateway11
Connect the PC to the Gateway12
Connecting to the Gateway Via Ethernet12
Changing the Subnet of the Connected PC12
Setup Web Server Security13
Navigate to the Login Page13
Login to the Fieldserver13
Select the Security Mode15
HTTPS with Own Trusted TLS Certificate16
HTTPS with Default Untrusted Self-Signed TLS Certificate or HTTP with Built-In Payload Encryption16
Setup Network17
Navigate to the Network Settings17
Routing Settings18
Ethernet 1 and Ethernet 2 Network Settings - LAN Mode19
Ethernet 2 Network Settings - WAN Mode20
MSA Grid - Fieldsever Manager Setup21
Choose Whether to Integrate the Fieldserver Manager21
User Setup22
Registration Process24
Login to the Fieldserver Manager28
Configure the Protonode30
Navigate to the Protonode Web Configurator30
Select Field Protocol and Set Configuration Parameters31
Setting Active Profiles32
Verify Device Communications33
Bacnet: Setting Node_Offset to Assign Specific Device Instances34
How to Start the Installation Over: Clearing Profiles35
Troubleshooting36
Lost or Incorrect IP Address36
Viewing Diagnostic Information37
Checking Wiring and Settings38
LED Functions39
Taking a Fieldserver Diagnostic Capture40
Factory Reset Instructions41
Internet Browser Software Support41
Additional Information42
Update Firmware42
Bacnet: Setting Network_Number for more than One Protonode on the Subnet42
Mounting43
Certification43
Physical Dimensions44
Change Web Server Security Settings after Initial Setup45
Change Security Mode46
Edit the Certificate Loaded Onto the Fieldserver47
Change User Management Settings48
Create Users49
Edit Users50
Delete Users51
Change Fieldserver Password52
Fieldserver Manager Connection Warning Message53
System Status Button54
Vendor Information - Huntner Fans55
Yaskawa Modbus RTU or Modbus TCP/IP Mappings to Bacnet, Metasys N2 and Modbus RTU55
Mitsubishi Modbus RTU or Modbus TCP/IP Mappings to Bacnet, Metasys N2 and Modbus RTU55
TRAK Modbus RTU or Modbus TCP/IP Mappings to Bacnet, Metasys N2 and Modbus RTU57
Specifications58
Warnings58
Compliance with en IEC 62368-159
Limited 2 Year Warranty60

Other manuals for MSA fieldserver ProtoNode FPC-N64

Startup Guide47 pages

MSA fieldserver ProtoNode FPC-N64 - Page 29

Table of Contents

Other manuals for MSA fieldserver ProtoNode FPC-N64