Quick Start Guide
1. Record the information about the unit. (Section 2.1 Record Identification Data)
2. Check that the ProtoNode and customer device COM settings match. (Section 2.3 Configuring Device
Communications)
3. If connecting to a serial device:
Connect the ProtoNode 3 pin RS-485 R1 port to the RS-485 network connected to each of the devices. (Section 3.1
Device Connections to ProtoNode)
4. If using a serial field protocol:
Connect the ProtoNode 3 pin RS-485 R2 port to the field protocol cabling (Section 3.2 Wiring Field Port to RS-485
Serial Network).
5. Connect power to ProtoNode 3 pin power port. (Section 4 Power up the Gateway)
6. Connect a PC to the ProtoNode via Ethernet cable. (Section 5 Connect the PC to the Gateway)
7. Setup Web Server Security and login via web browser. (Section 6 Setup Web Server Security)
8. Configure the ProtoNode to connect to the local network. (Section 7 Setup Network)
9. Integrate the ProtoNode with the FieldServer Manager or opt out. (Section 8.1 Choose Whether to Integrate the
FieldServer Manager)
10. Use a web browser to access the ProtoNode Web Configurator page to select the profile of the device attached to the
ProtoNode and enter any necessary device information. Once the device is selected, the ProtoNode automatically
builds and loads the appropriate configuration. (Section 9 Configure the ProtoNode)
3 Hunter Fans ProtoNode FPC-N64
To Next Page
Loading...
