3-21
BIOS Setup
ters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
Wake Up by PCI Card, Power On by Ring
These settings specify whether the system will be awakened from power sav-
ing modes when activity or input signal of the specified hardware peripheral
or component is detected. Setting options: Enabled, Disabled.
Resume By Alarm
The field is used to enable or disable the feature of booting up the system on
a scheduled time/date.
Date (of Month) Alarm
The field specifies the date for Resume by Alarm. Settings: 0~31.
Time (hh:mm:ss) Alarm
The field specifies the time for Resume by Alarm. Format is <hour>
<minute><second>.
Reload Global Timer Events: Primary IDE 0/1, Secondary IDE 0/1, FDD/
COM/LPT Port, PCI PIRQ [A-D]#
Global Timer Events are I/O events whose occurrence can prevent the system
from entering a power saving mode or can awaken the system from such a
mode. In effect, the system remains alert for anything which occurs to a de-
vice that is configured as Enabled, even when the system is in a power down
mode.
MSI Reminds You...
If you have changed this setting, you must let the system boot up
until it enters the operating system, before this function will work.
MSI Reminds You...
You need to install a modem card supporting power on function
for “Power On by Ring” function.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
