Starter and Charging System
65
11. Press a new bushing into the end cap until it is flush
with the casting.
See Figure 6.27.
12. Insert the seal into the end cap from the inside.
13. Install the positive brushes/cable stud assembly.
14. Install the insulator washer. See Figure 6.28.
15. Install the flat washer against the insulator washer.
16. Install the lock washer.
17. Install the nut that retains the positive brushes/cable
stud assembly.
18. Install the brush holder.
19. Insert the springs in the brush holder.
20. Install the negative brushes.
NOTE: The screws that anchor the negative brushes also
anchor the brush holder.
See Figure 6.29.
Figure 6.27
Bushing is flush with casting
Figure 6.28
Seal
positive brushes/cable stud assembly
Insulator washer
Figure 6.29
Negative brush
Brush holder
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
