3. Remove cut-out oil filter using the oil filter
wrench.
4. Clean sealing surface on connecting piece.
5. Check condition of new oil filter sealing ring
and coat it with oil.
6. Fit SOLAS shield (→ Page 157).
7. Screw on and tighten new engine oil filter
by hand.
8. Replace other oil filters in the same way.
9. Switch filter to normal position.
10. After each oil change and filter replace‐
ment, crank engine with starting system
(→ Page 167).
11. Check oil level (→ Page 208).
Oil filter replacement with the engine running
1. Reduce engine speed to <1100 rpm.
2. Remove cut-out oil filter using the oil filter wrench.
3. Clean sealing surface on connecting piece.
4. Check condition of new oil filter sealing ring and coat it with oil.
5. Fit SOLAS shield (→ Page 157).
6. Screw on and tighten new engine oil filter by hand.
7. Replace other oil filters in the same way.
8. Switch filter to normal position.
9. Check oil level (→ Page 208).
212 | Task Description | MW15550/06E 2012-02
TIM-ID: 0000006365 - 005
To Next Page
Loading...
Need help?
General